Analysis of the pollution ranking of wooden door panels

The door of the bedroom of the general family will use wooden doors, and the pollution of wooden doors in the home life is a concern of many consumers. Many consumers have asked Xiaobian, where is the source of wooden door pollution. The general sources of wood door pollution are: plate, paint, glue. Xiaobian specifically summed up the ranking of sheet metal.

NO.1 MDF

Also known as fiberboard and particleboard, it is a wood-based panel obtained by bonding together fibers such as wood, bamboo, straw, bagasse and the like with formaldehyde-containing glue. The veneer after the veneer is also called melamine board, solid wood particle board, and granular solid wood board. The amount of formaldehyde glue contained in each cubic meter of MDF is generally 400-500 kg. It is the highest formaldehyde content of all plates.

NO.2 multi-layer fir finger joint board

That is, other multi-layer solid wood fingerboards using formaldehyde glue. The fir is softwood and cannot be deep degreased and steamed. The formaldehyde-free glue cannot be used on the fir fingerboard. Generally, the multi-layered fir finger joint plate is three layers, and two layers of the three layers must be coated with a large amount of formaldehyde glue, and the glue content is not less than the blockboard. However, since the "finger joints" of the finger joints of the fir are exposed to the air, formaldehyde is more volatile than the "blockboard". Relative to blockboard, the formaldehyde content is higher, it is more volatile, and the natural environmental protection is worse than the blockboard.

NO.3 Blockboard

Also known as the large core board, the small wooden blocks are spliced ​​together in the form of extrusion with a glue containing formaldehyde, and then the artificial board of the surface of the two veneers is attached to the top and bottom. Blockboard can not be used alone, it must be equipped with a veneer. In this case, there are seven layers inside and outside, that is to say, the middle six layers are coated with formaldehyde glue, and the formaldehyde content can be imagined.

NO.4 veneer

Also known as veneer, the veneer or paper is coated with formaldehyde glue on a thin-density board or a particle board to decorate the surface of the furniture. The veneer is made of a “three plywood + 30 wire veneer” and cannot be used alone. It can only be used on the blockboard, splint and fir fingerboard.

NO.5 Solid wood finger joint board using formaldehyde-free glue

The same is the use of solid wood board as the raw material of the finger joint board, but the glue used in the production process is formaldehyde-free, there is no threat of excessive formaldehyde, it is the most ideal health and environmental protection wood board, can be used in any occasion, is Solid wood wooden door substrate with solid wood dosage of 95~98%.

Although this ranking looks a bit "horrible", the wooden doors of large-scale brands generally have factory standards when they are shipped. The standards are based on national regulations. Relatively speaking, they are only allowed to leave the factory with the lowest pollution. Consumers are When purchasing wooden door products, try to choose a wooden door manufacturer with credibility, integrity and strength.

FHM fence factory provides a variety of Fence Kits for your supplying chain/warehouse.You could have a multiple choice here. We have Post cap,Post Anchor,Chain Link Fence kits.

As to the surface treatment,we could do hot dipped galvanized and pvc coated in these kits. So that it could be attractive and resist the corrosion.

Our kits are easy to install and repair.

We have many kinds of chain link parts which are used in different section of the fence. You could inquiry us about it.

Fence Kits


Fence Fittings Accessories

Fence Fittings Accessories,Chain Link Fence Fittings,Green Chain Link Fence,Fence Connectors

DINGZHOU FEIHONG METAL MESH CO.,LTD , https://www.fhmfencing.com

Posted on